How do I adjust the door on a Mamava pod?

If the door of your Mamava pod is shutting too quickly or too slowly this article will help you adjust it.

XL V6 pods

Tools required:

  • Step ladder
  • Flat head screwdriver

  1. Access the pod by entering 8008# on the keypad.
  2. Place the step ladder inside the pod in the center of the floor.
  3. Remove the center roof panel by lifting straight up.XLV6_Closer_Adjustment_1
  4. Access the adjustment screws on the door closer by inserting a flathead screwdriver through the holes in the right roof beam. 
           
    XLV6_Closer_Adjustment_2
  5. The lower screw (marked with a “2”) adjusts the closing speed. Rotate clockwise to decrease the door closure speed, and counterclockwise to increase the door closure speed.
  6. The upper screw (marked with a “1”) adjusts the latching speed. Rotate clockwise to decrease the door latching speed, and counterclockwise to increase the door latching speed.

Screenshot 2025-05-28 at 1.18.41 PM (1)


XL V5, Original, Solo V1.1 pods

Tools required:

  • Step ladder
  • Flat head screwdriver

Use a flat screwdriver to adjust the closing speed screw on the end of the closer body (the lower screw, marked with a “2”). Rotate clockwise to decrease the closing speed, and counterclockwise to increase the closing speed.

The upper screw (marked with a “1”) adjusts the latching speed. Rotate clockwise to decrease the latching speed, and counterclockwise to increase the latching speed.

Screen Shot 2020-06-15 at 1.29.20 PM


Solo V2.0, V2.1, and V2.2 pods

Tools required:

  • Step ladder
  • 5/32" hex key

To increase the door closure speed, close the door, insert the 5/32” hex key in the top of the hinge and rotate clockwise.  Do not exceed 6 ratchet “clicks”.

Hinge_Increase_Speed

To decrease the door closure speed, close the door and insert a 5/32" hex key in the top of the hinge.  Press down firmly to disengage the ratchet.  Let the hex key rotate counter-clockwise to the new setting.  Allow the wrench to rise when complete.  

Hinge_Decrease_Speed


Flex V1.0 pods

Tools required:

  • Step ladder
  • 5/32" hex key

To increase the door closure speed, close the door, insert the 5/32” hex key in the top of the hinge and rotate clockwise.  Do not exceed 6 ratchet “clicks".

Hinge_Increase_Speed (1)

To decrease the door closure speed, close the door and insert a 5/32" hex key in the top of the hinge.  Press down firmly to disengage the ratchet.  Let the hex key rotate counter-clockwise to the new setting.  Allow the wrench to rise when complete. 

Hinge_Decrease_Speed (1)